Product Information

Options of SHM-25 + SHD2-08

Motor Cable

For connecting the driver and the motor of the moving part.

 

Model Cable length
SHM-MC050 500mm
SHM-MC100 1000mm
SHM-MC200 2000mm
SHM-MC300 3000mm

Encoder Cable

For connecting the driver and the encoder of the moving part.

 

Model Cable length
SHM-EC050 500mm
SHM-EC100 1000mm
SHM-EC200 2000mm
SHM-EC300 3000mm

Support Software

For configuring and changing the settings of the driver on a PC. The support software varies depending on the driver.

Model Cable length
SHD2-06 SHD2-08 SHD-16
SHD2-UTL  
SHD-UTL    

PC Connection Cable

For connecting the driver and the DOS/V PC.
Cable length 2000 mm
Model: SHD-PC

I/O Connector Set

Connector for inputting/outputting command signals to the I/O connector. The connector varies depending on the driver.

Model Applicable driver
SHD2-06 SHD2-08 SHD-16
SHD2-CN3  
SHD-CN3    

Various Connectors

If you will make the various cables yourself, the connectors in the following table can be used for them.

For power supply input terminal (TB1N) FRONT MSTB 2,5/9-ST Made by Phoenix Contact
For moving part output terminal(TB2N) FRONT MSTB 2,5/3-ST Made by Phoenix Contact
For driver communication connector (CN1) E6-200J-100 Made by Chuo
Musen Denki
For I/O connector (CN3) (SHD2) 10150-3000PE/10350-52A0-008 Made by
Sumitomo 3M
For I/O connector (CN3) (SHD) 10136-3000PE/10336-52A0-008 Made by
Sumitomo 3M
For sensor connector (CN4) 10114-3000PE/10314-52A0-008 Made by
Sumitomo 3M

Protocol Converter

Protocol converter for converting the parameters, position data, and speed data of the PLC (sequencer) to those of the linear shaft drive driver.
Standard support for the communication protocol of Mitsubishi PLC (type 4) and Omron PLC (host link mode) is available. (Support for other manufacturers is also available)

 

D90 Execute flag Set D91 to D95 and then set "1" to start transmitting and receiving data.
(Up to 14 data sets can be continuously transmitted and received)
D91 Command Set the type of the command to execute.
0: Read, 1: Write, 2: Save to FLASH
D92 SHD station number Set the station number of the linear shaft drive with which to communicate.
D93 PLC address Set the address number of the memory area in the PLC for reading and writing data.
D94 SHD address Set the address number of the memory area in the SHD.
D95 number of data sets Set the number of data sets to transfer after the addresses set in D93 and D94.

Related Product